Dosing pump EZO-PMP™
| Article number: | Part # EZO-PMP-red |
| Availability: | In stock (5) |
Extremely suitable for building your own dosing system.
The actual peristaltic pumping is done within the cassette. It has been designed to be easily detached from the motor and disassembled. The 12 volt motor and control system have been soldered together. Both components are designed to operate as one single unit.
|
Flow rate |
0.5ml to 105ml/mins |
| Accuracy | +/- 1% |
| Modes of operation | Continuous dispensing |
| Volume dispensing | |
| Constant flow rate | |
| Dose over time mode | |
| Connector | 5 lead data cable |
| Calibration | Single point |
| Supplied tubing | 15.24 cm |
| Tubing size | Any 5mm O.D. tubing |
| Data protocol | UART & I2C |
| Default I2C address | 103 (0x67) |
| Operating voltage | 3.3V – 5V (logic) |
| 12V – 24V (motor) | |
| Pump head | 2 meters |
| Data format | ASCII |
| Food safe | Yes |
The EZO-PMP™ comes with:
One peristaltic pump with controller, one data cable and one 5 pin male header.
