EZO-PMP™ Advanced Kit

€149,95
Article number: Part #EZO-ADV-PMP-Red
Availability: In stock (3)

The EZO™ Advanced pump kit comes with everything found in our original EZO pump kit and more!

Having the pump already mounted into an enclosure saves a lot of time.
The power connector and data cable with breakout board make integration onto your device FAST!

*This device comes defaulted to I2C mode*
*You can switch it back to UART mode if desired*


Enclosure:  
   
   
Size Metric: L = 145mm x W = 90.5mm x H = 80mm
  Inch: L = 5.7″ x W = 3.5″ x H = 3.1″
   
Enclosure protection IP-64
   
Enclosure material Body: Polycarbonate plastic
  Screws: Stainless steel
   
   
Pump: *This pump is set to I2C mode by defualt*
  *It can be change to UART mode.*
  *See data sheet for instructions*
   
Flow rate 0.5ml to 105ml/mins
Accuracy +/- 1%
Modes of operation Continuous dispensing
Volume dispensing
Dose over time mode
Constant flow rate
Dispense at startup
   
Connector 5 lead data cable
Calibration Single point
Supplied tubing 15.24 cm
Tubing size Any 5mm O.D. tubing
Data protocol UART & I2C
Default I2C address 103 (0x67)
Operating voltage 3.3V – 5V (logic)
  12V – 24V (motor)
power supply EU power socket (240v)
Pump head 2 meters
Data format ASCII
Food safe Yes

 EZO-PMP™ Advanced Kit Datasheet


0 stars based on 0 reviews