If you need a quote / large quantitie's / other questions / feel free to ask ! / [email protected]
Je winkelwagen is momenteel leeg
Product image slideshow Items
Als de pomp al in een behuizing is gemonteerd, bespaart u veel tijd.
De stroomconnector en datakabel met breakout board maken integratie op uw apparaat super eenvoudig.
| Enclosure: | |
| Size | Metric: L = 145mm x W = 90.5mm x H = 80mm |
| Inch: L = 5.7″ x W = 3.5″ x H = 3.1″ | |
| Enclosure protection | IP-64 |
| Enclosure material | Body: Polycarbonate plastic |
| Screws: Stainless steel | |
| Pump: | *This pump is set to I2C mode by defualt* |
| *It can be change to UART mode.* | |
| *See data sheet for instructions* | |
| Flow rate | 0.5ml to 105ml/mins |
| Accuracy | +/- 1% |
| Modes of operation | Continuous dispensing Volume dispensing Dose over time mode Constant flow rate Dispense at startup |
| Connector | 5 lead data cable |
| Calibration | Single point |
| Supplied tubing | 15.24 cm |
| Tubing size | Any 5mm O.D. tubing |
| Data protocol | UART & I2C |
| Default I2C address | 103 (0x67) |
| Operating voltage | 3.3V – 5V (logic) |
| 12V – 24V (motor) | |
| Pump head | 2 meters |
| Data format | ASCII |
| Food safe | Yes |
| Product bundels: We zijn gestopt met sets, kies je productbundel hieronder. |
|---|
Items van productcarrousel
